ChipQuik SMD4.5 Solder Alloy

Easily remove SMD parts with Chip Quik® removal alloy

Reduce heat and reduce damage to circuit boards and SMD parts during removal. Low melting point of 58°C (136°F)

Use with SMD291 flux (With solder iron or warm air bath)

• Apply flux to all leads.
• Melt CHIP QUIK® uniformly on all pins.
• Maintain alloy in molten state long enough to release chip.
• Lift chip from board with dental pick or vacuum pen.
  
  

CLEAN UP

• While molten, use cotton swab and flux to move excess to an unused section of board.
• While applying heat, polish each pad with a swab and flux until thoroughly clean.
• At room temperature, clean residue with alcohol pad.
• You are now ready to install the new chip.

4.5 ft of Chip Quik® material, removes up to 2700 SMD pins.

Specifications:

• Length: 4.5 feet (8x 6.5" lengths)
• Melting Point: 58°C (136°F)